Wind Sensor; Rain Gauge; Outdoor Temperature / Humidity Sensor; Getting Started - Oregon Scientific WMR200 Manual De Usuario

WIND SENSOR

1
2
3
1. Wind Direction
2. Wind vane casing
3. Anemometer
4. Solar power socket

RAIN GAUGE

Base and funnel:
1. Rain Gauge
2. Battery compartment
3. RESET button
1. Funnel
2. Indicator

OUTDOOR TEMPERATURE / HUMIDITY SENSOR

1
2
1. Temperature / humidity sensor casing
2. Solar power socket
3. RESET button
4. Battery compartment

GETTING STARTED

SET UP REMOTE WIND SENSOR

The wind sensor takes wind speed and direction readings.
The sensor is battery and solar powered operated. It is capable of transmitting data
to the base station wirelessly within an approximate operating range of 100 meters
(328 feet).
4
IMPORTANT Ensure that the wind sensor is pointing North to enable it to record
accurate readings.
NOTE The sensor should be positioned in an open area away from trees or other
obstructions.
To insert batteries:
1. Unscrew the anemometer from the wind sensor carefully.
2. Insert batteries matching the polarities (+ / -) and replace the anemometer. Press
RESET after each battery change.
3. Slide wind vane onto the end of the plastic attachment located on the aluminium
pole.
NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries
in temperatures below freezing.

SET UP REMOTE TEMPERATURE / HUMIDITY SENSOR

1. Holding sensor, twist and click to the left.
2. Pull sensor away from casing.
3. Insert batteries matching the polarities (+ / -). Press RESET after each battery
change.
3
4
4. Insert sensor into the casing, twist and click to the right to secure.
5. Slide temperature and humidity sensor onto the smaller end of the sensor connector.
4
2
1
3
2
1
4
5
3