Tabla De Contenido; Table Of Contents; Safety Information - Everbilt HDEFR50W Manual Del Usuario

Table of Contents

Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Safety Information

□ Do not splice the electrical power cord.
□ Do not allow the electrical cord to become submerged.
□ Do not use extension cords. They are a fire hazard and can
reduce voltage sufficiently to prevent pumping and/or damage
the motor.
□ Do not handle or service the pump while it is connected to a
power supply.
□ DO NOT remove the grounding prong from the plug or modify
the plug to protect against electrical shock. The power cord
is a three-wire conductor and includes a 3-prong grounded
plug. Plug the pump into a 3-wire, grounded, grounding type
receptacle. Connect the pump according to electrical codes that
apply.
DANGER: Do not pump flammable or explosive liquids
such as oil, gasoline, kerosene, ethanol, etc. Do not use
in the presence of flammable or explosive vapors. Using
this pump with or near flammable liquids can cause an
explosion or fire, resulting in property damage, serious
personal injury, and/or death.
DANGER: ALWAYS disconnect the power to the pump
before servicing.
DANGER: Do not touch the motor housing during
operation. The motor is designed to operate at high
temperatures. Do not disassemble the motor housing.
DANGER: Do not handle the pump or pump motor with
wet hands or when standing on a wet or damp surface, or in
water before disconnecting the power.
WARNING: Release all pressure and drain all water from
the system before servicing any component.
WARNING: Secure the discharge line before starting
the pump. An unsecured discharge line will whip, possibly
causing personal injury, and/or property damage.
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Care & Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
WARNING: Extension cords may not deliver sufficient
voltage to the pump motor. Extension cords present a
life threatening safety hazard if the insulation becomes
damaged or the connection ends fall into water. The use of
an extension cord to power this pump is not permitted.
WARNING: Wear safety goggles at all times when
working with pumps.
WARNING: This unit is designed only for use on 115
volts (single phase), 60 Hz, and is equipped with an
approved 3-conductor cord and 3-prong grounded plug.
Do not remove the ground pin under any circumstances.
The 3-prong plug must be directly inserted into a properly
installed and grounded 3-prong, grounding-type receptacle.
Do not use this pump with a 2-prong wall outlet. Replace
the 2-prong outlet with a properly grounded 3-prong
receptacle (a GFCI outlet) installed in accordance with the
National Electrical Code and local codes and ordinances. All
wiring should be performed by a qualified electrician.
WARNING: Protect the electrical cord from sharp objects,
hot surfaces, oil, and chemicals. Avoid kinking the cord. Do
not use damaged or worn cords.
WARNING: Failure to comply with the instruction and
designed operation of this unit may void the warranty.
ATTEMPTING TO USE A DAMAGED PUMP can result in
property damage, serious personal injury, and/or death.
WARNING: Ensure that the electrical circuit to the pump
is protected by a 15 Amp fuse or circuit breaker.
CAUTION: Do not lift the pump by the power cord.
CAUTION: Know the pump and its applications,
limitations, and potential hazards.
2