Section 1. Important Safety; Instructions; Safety Instructions - Jandy Stealth SHPF Manual De Instalación Y Funcionamiento

Section 1. IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
1.1

Safety Instructions

All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY
OR DEATH. Do not block pump suction as this can cause severe injury or death. Do not use this pump for wading
pools, shallow pools or spas containing bottom drains, unless the pump is connected to at least two functioning
suction outlets. Suction outlet (drain) assemblies and covers must be certified to the latest published version of
ANSI /ASME A112.19.8, or its successor standard, ANSI/APSP-16.
® ®
To reduce the risk of injury, do not permit children to use this product.
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide, or full
flow) valve position with the pump running.
Jandy pumps are powered by a high voltage electric motor and must be installed by a licensed or certified elec-
trician or a qualified swimming pool service technician.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH (For all permanently installed units
intended for use on 15 or 20 ampere, 120 through 240 volt, single phase branch circuits). Connect only
to a branch circuit that is protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if
you cannot verify that the circuit is protected by a GFCI. A GFCI should be provided by the installer and should
be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the
reset button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the
GFCI interrupts power to the pump without the test button being pushed, a ground current is flowing, indicating
the possibility of electrical shock. Do not use the pump. Disconnect the pump and have the problem corrected by
a qualified service representative before using.
Due to the potential risk of fire, electric shock, or injuries to persons, Jandy Pumps must be installed in accor-
dance with the National Electrical Code
ty and Health Act (OSHA
(NFPA ) online at www.nfpa.org or call 617-770-3000, or contact your local government inspection agency.
®
Incorrectly installed equipment may fail, causing severe injury or property damage.
• Do not connect the system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
• Trapped air in system can cause the filter lid to be blown off, which can result in death, serious personal injury,
or property damage. Be sure all air is out of the system before operating.
Jandy Stealth
® ™
(NEC ), all local electrical and safety codes, and the Occupational Safe-
® ®
). Copies of the NEC may be ordered from the National Fire Protection Association
®
|
Pumps Operation Manual
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
Page 3
ENGLISH
®