Grandstream GDS3710 Guía De Instalación Rápida página 5

Option A
Plug an RJ45 Ethernet cable into the (Class 3) Power
over Ethernet(PoE) switch.
Option B
Step 1:
Select an external DC12V, minimum 1A power source
(not provided). Wire correctly the "+,-" cable of the pow-
er into the "12V, GND" connector of the GDS3710 socket
(refer to the previous mounting page for instruction). Con-
nect the power source.
Step 2:
Plug an RJ45 Ethernet cable into a network switch/hub
or router.
Note:
Please refer to "Step 2" of "MOUNTING GDS3710" and
"GDS3710 WIRING TABLE" at the end of QIG for all the wiring
and connection illustration and instructions.
GDS3710 CONFIGURATION
The GDS3710 is by default configured to obtain the IP
address from DHCP server where the unit is located.
In order to know which IP address is assigned to your
GDS3710, please use GS_Search tool as illustrated in fol-
lowing steps.
Note:
If no DHCP server is available, the GDS3710 default IP ad-
dress (after 5 minutes DHCP timeout) is 192.168.1.168.
~ ~
5
Step 1:
Download and install GS_Search tool:
http://www.grandstream.com/support/tools
Step 2:
Run the Grandstream GS_Search tool on
a computer connected to same network/
DHCP server.
Step 3:
Click on
detection.
Step 4:
The detected devices will appear in the
output field as below.
~
button to start device
~
6