Tabla de contenido
Publicidad
•
Electrical Safety – IEC 60950, with CB member national deviations
Further, the equipment has been certified as compliant with the national standards as detailed below.
National Electromagnetic Compliance (EMC) Statements of
Compliance
FCC statement (USA only)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with
the instruction manual, it may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case users will be required to take whatever
measures may be necessary to correct the interference at their own expense.
ICES statement (Canada only)
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (Ethernet Routing Switch 5600 Series) does not exceed the Class A limits for radio-noise
emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Règlement sur le brouillage radioélectrique du ministère des Communications
Cet appareil numérique (le commutateur ERS 5600 Series) respecte les limites de bruits radioélectriques visant
les appareils numériques de classe A prescrites dans le Règlement sur le brouillage radioélectrique du ministère
des Communications du Canada.
CE marking statement (Europe only)
EN 55022 statements
This is to certify that the Ethernet Routing Switch 5600 Series equipment is shielded against the generation of
radio interference in accordance with the application of Council Directive 2004/108/EC. Conformity is declared
by the application of EN 55022 Class A (CISPR 22).
EN 55024 statement
This is to certify that the Ethernet Routing Switch 5600 Series are shielded against the susceptibility to radio
interference in accordance with the application of Council Directive 2004/108/EC. Conformity is declared by
the application of EN 55024 (CISPR 24).
EN 300386 statement
The Ethernet Routing Switch 5600 Series complies with the requirements of EN 300386 V1.3.3 for emissions and
for immunity for a Class A device intended for use in either Telecommunications centre or locations other than
telecommunications centres given the performance criteria as specified by the manufacturer.
European Union and European Free Trade Association (EFTA) notice
All products labeled with the CE marking comply with R&TTE Directive (1999/5/EEC) which
includes the Electromagnetic Compliance (EMC) Directive 2004/108/EC and the Low Voltage
Directive 2006/95/EC issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms (ENs). The equivalent
international standards are listed in parenthesis.
•
EN 55022 (CISPR 22)–Electromagnetic Interference
•
EN 55024 (IEC 61000-4-2, -3, -4, -5, -6, -8, -11)–Electromagnetic Immunity
•
EN 61000-3-2 (IEC 610000-3-2)–Power Line Harmonics
Publicidad
Tabla de contenido
