Before You Begin; Installing The Switch On A Table Or Shelf - Nortel 100 Serie Manual Del Usuario

Before you begin

Ensure the area where you install and use the BES 100 and 200 Series switch meets the following
environmental requirements:
• Ambient temperature between 32° and 104° F (0° and 40° C)
• Relative humidity between 5% and 85% noncondensing
• No nearby heat sources such as hot air vents or direct sunlight
• No nearby sources of severe electromagnetic noise
• No excessive dust
• Adequate power source within six feet; one 15-Amp circuit required for each power supply
• At least 2 inches (5.08 cm) on each side of the switch unit for ventilation
• Adequate space at the front and rear of the switch for access to cables
If you are installing a single Business Ethernet Switch on a table or shelf, ensure the surface can
support at least 15 to 20 pounds (7 to 9 kilograms).

Installing the switch on a table or shelf

You can install a single Business Ethernet Switch on any flat surface that can safely support the
weight of the switch and attached cables (15 to 20 pounds or 7 to 9 kilograms).
instructions on installing the switch on a table or shelf.
Figure 1 Installing switch on table or shelf
1 Attach the rubber feet at the marked locations. 2 Set the switch on a table or shelf.
Note: Allow at least 2 inches (5.1 cm) on each side for proper ventilation and at least 5
inches (12.7 cm) at the back for power cord clearance.
Nortel Business Ethernet Switch 100 and 200 Series Regulatory Information
Up Spee d
Link/ Act
49
Dow n
50
Base 1
Statu 3
s
5
PWR
Cons Rese t 7
ole
9
11 11 PoE
Link/ Act
13
PoE 15
17
2
4 19
6 21
8 23 Link/
Act
10 10 25
12 12
27
PoE
14 14 29
16 31
18 33
20 20 35
Link/
22 Act
37
24 24
39
26 41
28
30
32
34
36
38
40
42
Figure 1 provides
43
BES 220
45 -48 T-P
WR
47
44
46
48
7