Directions For Use - Omega H3000B Manual

DIRECTIONS FOR USE

·Before using the appliance for the first time, clean its food contact parts thoroughly. (See 'Chapter 4: Maintenance')
This product will not start working before all the parts and components are correctly
assembled. Please install and use the product as follows:
1
2
3
4
5
7
BUTTON OPERATION INSTRUCTIONS:
· FORWARD (ON) BUTTON: NORMAL USE
· "0" STOP
· REVERSE (REV) BUTTON: USE WHEN PULP BLOCKS OUTPUT OR
THE MOTOR IS LOCKED. AUGER WILL BEGIN TO REVERSE. AFTER
THIS BUTTON IS RELEASED, THE AUGER WILL STOP REVERSING.
IF THE "FORWARD" (ON) BUTTON IS PRESSED AGAIN, THE AUGER
WILL RESUME FORWARD RUNNING.
1. TURN THE BODY LOCKING LATCH UP AND PLACE THE
CENTER POSITION OF THE DRUM INTO THE OPENING IN
THE CENTER OF THE FRONT OF THE BODY.
2. HOLD THE DRUM & FEED CHUTE WITH ONE HAND AND,
PRESS THE BODY LOCK LATCH WITH THE OTHER HAND,
AND THE DRUM & FEED CHUTE WILL BE AFFIXED TO THE
BODY.
ALIGN THE SCREW END OF THE AUGER WITH THE
HOLE ON THE BODY OF THE MACHINE, AND PUSH INTO
THE MACHINE. (IN CASE OF MISALIGNMENT, ROTATE THE
AUGER SLIGHTLY TO REACH ALIGNMENT
EASILY)
SET THE END OF THE JUICING SCREEN WITH LARGER HOLE
IN THE AUGER FROM THE TAIL, AND ALIGN THE THREE
BUCKLES ON THE JUICING SCREEN WITH THE THREE
SLOTS IN THE DRUM AND PUSH SCREEN ONTO AUGER.
STAGGER THE THREE BUCKLES ON THE ENDCAP AND THE
THREE BUCKLES ON THE DRUM, PUSH THE ENDCAP INTO THE
DRUM, AND THEN ROTATE COUNTER CLOCKWISE TO TIGHTEN
THE END CAP ON THE DRUM SECURELY.
PUT THE JUICE CUP NEAR THE BODY OF THE MACHINE,
AND ALIGN THE OPENING OF THE CUP WITH THE BOTTOM
OF JUICE NOZZLE OF THE CONTAINER FOR JUICING.