Publicidad
L
x 3
FIG. 4A
4. Attach Rafix Double Bolts (L) to the Vertical Divider (A) in three places. One in the lower back
corner and two in the same shelf hole location you chose for the bottom shelf on the side panels.
See FIGURE 4A. The Rafix Double Bolt consists of two parts that screw together through a
predrilled hole in the Vertical Divider. See FIGURE 4B.
Important: If you have chosen to combine door kits as shown in the chart in the previous step,
you must locate the Rafix Double Bolts two holes up from the bottom for proper location of Bottom
Shelf. See FIGURE 4A. For all other combinations, the bottom shelf can be placed in any desired
location.
M
x 2
Stain Test Area
5. Attach the Vertical Divider (A) to the Top Shelf (B) with two Black Screws (M) through the
predrilled holes in the Top Shelf and into the pilot holes in the top edge of the Vertical Divider.
Make sure the Rafix Cams (J) face away from the side the Vertical Divider is attached. The wood
trim on the Vertical Divider should face out when attached. See FIGURE 5. Start each screw part
way into the Vertical Divider before tightening all the rest of the way.
Locate Rafix Double
*
Bolts here when
using Door Kits as
instructed below.
FIG. 5
*
FIG. 4B
236W/237W — Page 5
Publicidad
