Publicidad
FIG. 6
6. Attach the Left Side Panel (C) to the Top Shelf (B) by sliding the Rafix Bolts (K) into the Rafix
Cams (J). Tighten the cams. Repeat and attach the Right Side Panel (D) to the Top Shelf (B).
Attach the Crown (E) in the same way, tightening the Cams to hold it to the Top.
Rounded edge faces up and
towards the front of the unit.
FIG. 7
7. Carefully turn the unit over on its face, with the top up, on a protective surface. Install the two
Bottom Shelves (F) sliding them over and down onto the Rafix Bolts (K & L). Tighten the cams. In
the same way install two Back Supports (G) sliding them onto the Rafix Bolts (K & L) in the lower
back corners of each side panel and vertical divider. Make sure the rounded edges of each Back
Support (G) is facing up and towards the front of the unit. Tighten the cams. See FIGURE 7.
Page 6 — 236W/237W
E
D
B
C
Publicidad
