Publicidad
N
236W – 5
236W – 31
237W – 6
237W – 34
FIG. 8A
8. With the unit still on its face, measure from top left to bottom right (
top right (
). Measurements should be equal. If the line (
Side Panel (C) until measurements are equal. If line (
Panel (D). See FIGURE 8A.
Place the two Backs (H) onto the unit so that tops of the backs are flush with the top shelf and
equal distance from the two side panel edges. Also, make sure the backs are properly situated
so that the edges with no predrilled holes are in the center. Insert Screw (N) in the predrilled
holes around the outer edge of the Backs (H). For the 237W, insert six Screws (N) with Finish
Washer (O) (five each for the 236W) in the gap between the two backs into the Vertical Divider.
This gap must be centered in the middle of the Vertical Divider. Use an imaginary line between the
screws in the outer edges to determine location of each screw and washer.
Q
R
236W – 8
236W – 8
237W – 16
237W – 16
FIG. 9A
9. Stand the unit upright. Determine where you want to locate the Adjustable Shelves (I). There are
two Adjustable Shelves (I) for the 236W and four Adjustable Shelves (I) for the 237W. Tap the
Shelf Brackets (Q) into the holes with the flat side down. See Figure 9B. Insert the shelf as shown.
Secure the shelf to the unit using Screw (R) through the holes in the bottom of the Shelf Bracket
into the Shelf.
O
FIG. 8B
) is longer, tap bottom of Left
) is longer, tap bottom of Right Side
Q Q
) and from bottom left to
Q
R
FIG. 9B
236W/237W — Page 7
Publicidad
