Laser Classification - ADA INSTRUMENTS ADA COSMO 120 VIDEO Manual De Instrucciones

COSMO 120
4
11. Additional calculations
12. Main result
13. Reference point
Display in Digital Camera mode
Built-in digital camera shows the target directly on the
display.
The instrument takes measurements with the help of
crosshairs, even if the laser dot is not visible (in bright
illumination).
The brightness of the display can be adjusted with
buttons.
When the digital camera is used for close targets (<10m) the
laser dot may not coincide with the image in the center of
the display. In this case you should rely on the actual laser
dot for targeting the object.
Inserting / Replacing Batteries
Remove the battery compartment lid.
Insert the batteries. Pay attention to the polarity.
Close the battery compartment.
The batteries should be replaced, when the battery voltage
is too low.
VIDEO
and
Batteries should be removed if the device will not be used
for a long time (danger of corrosion).
Use alkaline or Li-batteries.
NOTE:
We reccomend to use LI /IRON Batteries (energy-plus bat-
tery). Approximate time of continious operation*:
• LI / IRON (4 000 mAh) - about 5 hours
• NiMh (2 000 mAh) - about 3.5 hours
*in condition of operation under environment temperature
20°C and also average values of instrument settings (bright-
ness, contrast and so on).

Laser classification

The instrument is a laser class 2 laser product with power
< 1 mW and wavelength 635 nm. Laser is safety in ordinary
conditions of usage.
Reference point
Always select the reference point before the measurements.
Press button (5) to select the reference point. The reference
point can be: back part, front part, end-piece, thread for the
tripod. Selected point is displayed on the display by the icon