Safety System Test (units with Free Hand
control)
DANGER
Amputation hazard
This snowthrower is equipped with several mechanical
safety systems designed to keep the operator safe while
using the unit. Check the operation of these systems
regularly using the safety system tests listed. If the unit
fails to operate as described, DO NOT operate it. See
your authorized dealer for service immediately.
Test 1 - Auger/Impeller Control
With the engine running:
• Press down on the auger control lever. (The auger/
impeller should rotate)
• Release the auger control lever. (The auger/impeller
must stop within 5 seconds)
Test 2 - Traction Drive Control
With the engine running and speed control in 1st gear:
• Press down on the traction control lever. (The unit
should move forward)
• Release the traction control lever. (The unit must stop)
Test 3 - Free Hand Control
With the engine running:
• Engage the auger and traction control levers, then
release the auger control lever. (Both controls should
remain engaged)
• Next, release the traction control lever. (Both controls
must release)
8
Features and Controls
Engine Features and Controls
For engine features and controls, please refer to the engine
operator's manual.
Snowthrower Features and Controls
Compare Figure 3 with the table below.
F
G
B
A
O
N
D
H
Figure 3
K
K
L
M
C
I
J
E