Items Required For Operation - Maverick MCS-29BL-80WP Manual De Instrucciones

Items required for operation

Li-Po
Battery
2-3 cell LiPo (7.4 to 11.1v)
battery pack
Caution
Always disconnect the battery from the ESC when you are fi nished using your vehicle. The switch on the
ESC controls the power that is delivered to the receiver and servos. The controller will always draw current
when it is connected to the battery and will completely discharge batteries if they are connected for long
durations. This may cause failure of your batteries.
Caution
4 * AA Batteries for the
Transmitter
Battery Connector
For 2S or 3S LiPo packs we recommend a 25C rating or better. For 25C rated packs we
recommend a minimum of 4000mAh. For 30C+ rated packs we recommend a minimum of
3500mAh. Do not use NiCd/NiMH battery chargers for LiPO batteries.
If you do not use a special charger for LiPO batteries, they will be damaged. Using
batteries with a lower C rating may result in damage to your batteries.
Maximum battery dimensions Maximum battery dimensions
47mm 47mm
48mm
When using 3S LiPo batteries it is important to monitor the battery temperature.
Battery temp should not exceed 60°C (140F)
LiPo Battery Charger
Do not use NiCd/NiMH battery chargers for LiPO batteries.
If you do not use a special charger for LiPO batteries, they will be
damaged.
31mm 31mm
38mm
143mm 143mm
140mm
Poor quality battery connectors can be a
roadblock to performance. Avoid the common
"white plastic" connectors commonly seen on
many battery packs. A fast brushless setup
will draw many times the power that these
connectors can safely handle. For this reason
your Maverick ESC is equipped with a high
capacity connector.
4
Auto-Lipo is pre-set to ON from factory.
P.10
Reference Section