Unpacking; Assembly; Tools Needed - KNOVA KN BD-305 Manual Del Usuario

UNPACKING

Refer to Figure 1.
Check for shipping damage. If damage has occurred, a claim
must be filled with carrier. Check for completeness.
Immediately report missing parts to dealer.
The sander comes assembled as one unit. Additional parts
which need to be fastened to sander, should be located and
accounted for before assembling.
A Sander Assembly with Abrasive Belt and Disc
B Miter Gauge Assembly
C Belt Table
D Disc Table
E Sanding Disc Cover with Dust Port
F Dust Nozzle Adapter (1-1/2" OD, 1-1/4" ID)
G Knobs for Disc Table (2), D6 Flat Washers (2), Lever
Handle for Belt Table, D8 Flat Washer, Phillips Screws for
Disc cover (3), D4 Flat Washers (3), and 3mm Hex Wrench.

ASSEMBLY

Refer to Figures 2 - 6.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING: Do not operate machine until completely
assembled. Do not operate machine until you have completely
read and understood this manual.
NOTE: The specifications, photographs, drawings and
information in this manual represent the current model when
the manual was prepared. Changes and improvements may
be made at any time, with no obligation on the part of Knova
to modify previous delivered units.
TOOLS NEEDED: While assembling or adjusting your belt
and disc sander, you will need the following tools:
• 3mm Hex Wrench
• Combination Square
• Phillips Screwdriver
MOUNT SANDER
Refer to Figures 2 and 3.
Choose a suitable location to mount the sander. The sander
must be installed in a place with ample lighting and correct
power supply. To install sander:
• The sander must be bolted to a firm, level surface.
• Make sure there is plenty of room for moving the
workpiece. There must be enough room that neither
operators nor bystanders will have to stand in line with
the wood while using the tool. Allow room so that belt
assembly can be positioned horizontally.
• Insert bolts through the 2 holes in the base to fasten the
sander to the mounting surface. Secure bolts to
underside of mounting surface with lock washers and
hex nuts. (Fasteners not included).
• Sander can be installed on a workbench or a tool stand
(see Recommended Accessories, page 10).
Figure 1
Unpacking sander
C
D
Figure 2
Insert mounting hardware into the holes in the sander base
• Figure 3 shows the base dimensions with 2 mounting
holes, and required space to allow for table assembly
and belt assembly.
o
Figure 3 - Shows Sander's Base Dimension (B),
3
Required Space (S), and Mounting Holes (o)
A
G
S
B
o
6-3/4"
23"
B
F
E