Mounting The Fascia Door - ROSIERES BI SD 177 Manual Del Usuario

Mounting the fascia door

• Ensure that there is a gap of 3 to 4mm between the non- hinged side and the cabinet wall.
• Locate the slider in the bracket and fix the slider to the fascia door 20 to 22mm from the edge of
the fascia as shown in figure 11, ensuring that the slider is positioned centrally and horizontally
within the bracket. Tighten securely by hand.
• Fill the gap on the non-hinged side with the gasket/seal strip provided, as shown in Fig. 12.
• The finished look for the door sliders should be similar to those shown in Fig. 14, which shows 2
sliders in place.
• Ensure the appliance door opens, closes and seals properly.
Once complete, and if you are happy with the fit of the appliance in the cabinet, bend and snap the
parts of the white spacers marked 'S' as shown by the dotted outline in fig. 13. Leave the rest of
the spacer cover in place over the metal plates.
Important: After completing the installation, check that the appliance is secured within the unit
and that the door(s) close and open properly. If there is no resistance from the door seals when
opening the doors, then it is probable that the appliance and/or decor doors are not fitted
properly.
17