Safety Instructions - Altrad LB 140 Manual Del Usuario

INSTALLATION
Install the mixer on a hard and horizontal soil in order
to ensure a good stability to the machine.
Clear the surroundings of the machine from all thing
likely to occasion a risk of accident or to impede the
operator.
Before starting your mixer make sure that :
Petrol driven mixer
• Your engine is supplied without oil.
Before any starting, fill up with oil (l0W 30
preferably).
• Fill up with petrol 3 stars unleaded.
• Before starting, refer to the instructions given by
the manufacturer of the engine.
Electric driven mixer
• The tension of the network is 230 volts on two
wires.
• Minimum capacity of the meter should be 5 Amps.
• The motor hood set benefits from double insulation
class II protection
electromagnetic on-off switch.
• Foresee a two wires supply cable having a section
of 2,5 mm2 for a maximum length of 50 m
(equipment class II no need for a ground wire). If
length is more than 50 m, foresee a cable with a
bigger section.

SAFETY INSTRUCTIONS

General
Before starting your mixer, check that :
• all protection devices are in position and good
condition.
• Nobody is into contact or close to the mixer, and
no tool is leaning against it.
Petrol driven mixer
• Do not use a petrol driven mixer for underground
works or in an area badly ventilated.
GB
grade IP 44, and
• Do not smoke when filling petrol.
• Let the engine hood open for a good ventilation.
CAREFUL : On mixers powered by an electric
single phase motor, avoid to make the drum turn
on no load ; this will lead to overheating of the
motor.
Electric driven mixer
• Never let a cable rolled on its support, this will
cause impodant drops of tension and lead to
overheating.
• The line must be fitted with fuses or circuit
breaker to ensure the protection.
• Do not plug in and use the electric motor without
making sure that the motor hood is closed.
MAINTENANCE
• After each use, clean the inside and the outside of
your mixer. If you wash it with a high pressure
cleaner, make sure that the water projections do
not reach the motor.
• For a good and efficient leaning of the drum, use a
shovel of gravels and water.
• Do not forget from time to time to grease the
bearing of the bracket, a hole is foreseen for this.
• The bearings of the drum and of the driving axle
are greased for life.
• The slew ring is made of synthetic material, high
resistance, unalterable, maintenance and greasing
free, which participates efficiently to the reduction
of sound nuisances.
• Sound pressure 74 dB(A) to 1 m.
13