Dirty Water Tank - Bissell PET STAIN ERASER 2842 Serie Manual Del Usuario

After-Cleaning Care
For more tips on how to maintain your machine, visit support.BISSELL.com.
1.
Remove the Formula Tank
by grabbing the sides and
pulling outward.
4.
Rinse all components and
allow to dry. See steps for
"Removing & Emptying the
Dirty Water Tank" on page 6.
7.
To replace the Removable
Suction Lens, attach the front
lip to the front of the machine
near the Brush Roll. Rotate the
lens toward the machine until
"clicked" into place.
NOTICE
To reduce the risk of a leaking condition, do not store where freezing may occur. Damage to internal
components may result.
WARNING
before performing maintenance or troubleshooting.
2.
Release the Removable
Suction Lens by raising the
latch at the top and pulling
outward.
Note: Be sure to empty the
Dirty Water Tank prior to
removing the Brush Roll.
5.
Sit machine upright.
Replace the Brush Roll by
carefully lining up the opposite
end as shown.
8.
Click the Formula Tank Cap
back into place. Ensure it is
secure.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect from charger
3.
Sit machine upright on a
flat surface. Pull the latch on
the Brush Roll Cover Plate to
open. Grab the brush by its
handle and pull out.
Note: Pet Tool follows the
same steps.
6.
Replace Brush Roll Cover
Plate by first sliding into the top
and then rotating downward
until "clicked" into place.
9.
Replace the Formula Tank
back onto the machine until
"clicked" into place.
BISSELL.com 7