Product Specifications - Homewerks TOSCA H09L-821-ORB Manual Del Usuario

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Min. flow rate: 1.2 GPM (4.5 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Oil rubbed bronze finishes
ASSEMBLY INSTRUCTIONS
1.
Shut off water supply and remove old
faucet.
NOTE: Each valve stop should be
turned clockwise.
2. Remove the preassembled metal
washer (1) and nut (2) from the spout
assembly (3) and place the spout
assembly (3) through the center hole
of the sink.
From under the sink, thread the metal
washer (1) and nut (2) onto the spout
assembly (3). Turn the nut (2)
clockwise to secure the spout
asssembly (3) to the sink.
3. Position the hot and cold handle
assemblies (1 & 2) on the sink. Ensure
that the handles are installed pointing
away from the spout assembly (3).
From underneath the sink, thread the
washers (4) and brackets (5) onto the
hot and cold handle assemblies (1 &
2). Hand-tighten the brackets (5).
Secure the handle assemblies (1 & 2)
to the sink by inserting two locking
screws (6) into each bracket (5).
Securely tighten.
4.
Attaching the Hose:
Align the blocks (1) and tabs (2) on the
quick connects (3). Push the quick
connects (3) firmly upward and snap
onto the blocks (1). Pull down
moderately to ensure each connection
has been made. If it is necessary to
remove the hose (4), press on the tabs
(2) and pull the quick connects (3)
down.
www.homewerksww.com
1
3
2
1
2
3
1
3
5
4
1
2
3
4
Ceramic cartridge
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
5.
Connect a 1/2 in. IPS faucet
connector or coupling nuts (not
included) with 3/8 in O.D. ball-nose
risers (not included) to the water
supplies underneath the sink using
wrenches (not included).
NOTE: Refer to the local plumbing
codes for permissible types of water
supply connectors.
6. Before tightening the faucet
connector to the water supply, apply
a second wrench to the supply tube
fitting. This will prevent the supply
tube from moving or twisting when
tightening the faucet connector. Do
not overtighten.
7. Remove the stopper (1) and flange
(2) from the pop-up assembly (3).
Screw the nut (4) all the way down
onto the pop-up assembly (3) and
then push the gasket (5) down.
2
4
6
8.
Apply silicone sealant (not included)
to the underside of the flange (1).
2
SPECIFICATIONS
5
6
7
1
2
8
5
4
3
1