Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
13. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
L2 button - (not applicable for this fan)
REV button - used to REVERSE blade direction
(fan must be set on low before reversing
blade direction)
14. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF
slider switch on wall control, then set to the ON
position. Test light and dimmer function and then
test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by
pressing the L1 button; test the dimmer function
by pressing the L1 button and holding it down for
up to 5 seconds. Test fan speeds with the
different fan speed buttons. If the wall and/or
handheld remote control operate(s) all of the
functions of the fan and light, battery/batteries
has (have) been installed correctly. If the wall
and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Fan must be on LOW before setting the fan to
reverse direction. Use "reverse" button (REV) to
recirculate air depending on the season.
NOTE: If the wall control/handheld remote
control interferes with other appliances, turn off
the power first and then go back to the
instructions in Section 12 (page 10).
(switch not functional on handheld
remote)
page 11
-
1 1
-
2 2
handheld
wall control
remote control
motor housing
Publicidad
Capítulos
Tabla de contenido
