Adjusting The Gmos-Lan-01 - Axxess GMOS-LAN-01 Instrucciones De Instalación

Adjusting the GMOS-LAN-01

Chime level adjustment:
• Turn the vehicle off but leave the keys in the ignition. Open the driver's door and leave it open;
chimes will be heard.
• Wait 10 seconds, and then with a small flat-blade screwdriver, adjust the potentiometer clockwise
to raise the chime level; counterclockwise to lower the chime level.
Note: The potentiometer is located on the side of the interface where the 16-pin harness with
stripped leads is connected to.
• When the chime is at the desired level, remove the keys from the ignition. This will lock the chime
level in at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on the steering wheel
to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, locate the Black/Yellow wire
on the GMOS-LAN-01 harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level is set, it will
stay at that level until the Black/Yellow wire is tapped to ground again.
Axxess Integrate
Installation instructions for part GMOS-LAN-01
axxessinterfaces.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
•
metraonline.com
K P
®
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION