Troubleshooting Chart - edenox DBM-211-S-W Manual De Instrucciones

To protect the environment, deliver waste equipment to a suitable facility in compliance with
applicable regulations.
Make sure that the electrical equipment is
delivered to a facility in which it will be
disposed of properly.
Some of the materials used may be stored
temporarily, and some must be delivered
immediately to a suitable facility.
In each case the environmental protection
regulations must be observed.
5. TROUBLE-SHOOTING
5.1 Trouble-shooting information.
5.1 TROUBLE-SHOOTING INFORMATION.
IMPORTANT!!!
Electrical subassemblies may be replaced only by an authorised service technician.
It must be made a principle to disconnect the power cable from the power supply before
electrical components are replaced.
It must be made a principle to disconnect the power cable from the power supply before
electrical components are replaced.
FAULT
The chamber of the bain-marie
does not heat up; the switches and
the thermoregulator are on; the
control lamp does not work.
The water in the bain-marie is
insufficiently heated.
The control lamp of the heating
elements does not switch on,
though these elements heat up.
9
edenox.com
POSSIBLE CAUSE
- Power supply failure.
- The terminals of the conductors
loosened on the power strip.
- The thermoregulator or the
thermal switch is damaged.
- The switches are damaged.
- Some heating elements are
disconnected.
- Heating elements are damaged.
- Control lamp burnt out.
- The electrical circuit of the
control lamp is open.
Before disposing of the device, check its
technical condition.
In particular, check the construction elements
which may cause leakage when disposed of.
Different parts of the device are disposed
differently, depending on their features (e.g.
metals, oils, lubricants, plastic, rubber, etc.).
REMEDY
Connect to power supply.
Appropriately fix the conductors to
the power strip.
Replace the damaged components.
Check that the heating elements
are properly connected.
Replace the damaged components.
Replace the control lamp.
Repair the wires of the control
lamp.
ENGLISH