Dyna-Glo DGA550SSP Manual Del Usuario página 8

CARE AND MAINTENANCE
Check the Flame in the Firebox
Formaximumfuelefficiencyandcookingperformance,
flameshouldbeablue-yellowcolorandbebetween
1 - 2 inches high.
Tochecktheflame,viewtheflamethroughtheholesin
therightsideofthefirebox.
Removing the Burner Assembly
1. Make sure all control knobs are in the OFF position,
gas supply valve is closed, and the gas hose is
disconnected from the gas supply.
2. Open lid and remove warming rack, cooking grates,
and heat tents.
3. Remove cotter pins at back of burners to detach
burners from brackets.
4.Slideburnersoutoffirebox.
5. Detach ignition wire from ignitor as shown.
Cleaning the Burner Assembly
1. Make sure the grill is cool. Turn gas off at the control knobs and propane tank.
2. Disconnect LP gas cylinder from hose and regulator.
3. Remove warming rack, cooking grates and heat tents.
4. Detach burner by removing the cotter pins at the back of the burners to detach them from the
brackets.
5. Detach ignition wire from electrode by hand only. DO NOT use pliers or any other tool as it may
damage the electrode or wire.
6. Lift burner slowly.
7. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.
8. Ensure burner is free of any damage. If damage is found, replace with new burner.
9. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris.
2 in.
Good Flame
24
Yellow Yellow
Light Blue Light Blue
Blue Blue
Bad Flame