Installation Steps - AVS Ventvisor Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
Remove tape liner from rear flange. Peel back 2" (5 cm) of tape liner from each end of lateral flange.
free end
lateral flange
free end
rear flange
3
front flange
Insert the rear end flange of the visor into the rubber window channel first. Then flex the visor slightly and rotate the visor into position
inside the rubber window channel.
window guide
lateral flange
trim
plastic mirror cap
visor
rubber window
channel
door glass
NOTE: Insert the front end flange of the
4
visor BETWEEN the plastic mirror cap
cross section of visor in place
and the rubber window channel.
With the visor in its final position, remove the remaining tape liner To ensure good adhesion of tape apply pressure along the
by pulling on free ends. backside of the visor flanges.
5 6
Roll window up and leave up for 24 hours to allow adhesive to
cure.
7
Page 2 of 3