Identification - Fanimation SHOWROOM BREWMASTER FP1280 220 Serie Manual Del Usuario

This manual is designed to make it as easy as possible for you
o t a s s e m l b
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
WARNING
Unpacking Instructions and Parts Identification
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
WARNING
FP1280**-220 Motor Assembly and Hardware Parts Identification
FP1280
Motor Assembly with
Switch Cap Receiver (1)
Hardware Bags
Wire Nuts (3) Lag Bolt,
1/4" x 2" (4)
Flat Washers,
Ø5 x Ø14 x 1mm (4)
, e n i s a t , l l o p r e t a
• One stepladder
• One wire stripper
Punch Tool (1)
Belt Clamps (2)
Rivet Tool (1)
"J" Lag Bolt,
1/4" x 2" (1)
, e a n d m a n i a t n i
Wiring outlet box and box connectors must be of type re-
quired by local code. The minimum wire would be a 3-con-
ductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 15.24 m (50 ft.)
15.24–30.48 m (50 –100 ft.)
Place the parts from the loose parts bags in a
small container to keep them from being lost. If any parts
are missing, contact your local retailer.
Check to see that you have received the following parts:
If you are uncertain of part description, refer to
exploded view illustration.
Assembly with hardware parts (Figure 1)
Assembly and hardware parts (Figure 2)
Wall Control (1)
#6-32 screws (2)
NOTE: The illustration shown is not to
scale or its actual configuration may vary.
Parts and packings subject to change
without notice.
Rivets, 3/32" x 7/32" (8)
& Rivet Washers,
0.1 x 0.23 x 0.35 mm (8)
y o r u c e l i n i g a f n
Materials
Wire Size A.W.G.
1 ( mm
( mm
)
2
)
2