Identification - Fanimation SHOWROOM BREWMASTER FP1280 220 Serie Manual Del Usuario

Unpacking Instructions and Parts Identification (continued)
FP10 (Short)/FP20 (Long) Pulley Assembly and Hardware Parts Identification
FP10
Short Neck
Pulley
Assembly (1)
Hardware Bags
1/4" x 2 Lag Bolts (4), Traditional Blade Screws,
& Flat Washers,
Ø5 x Ø14 x 1mm (4)
NOTE: If you are uncertain of part description, refer to exploded
view illustration. (Figure 2, page 17)
NOTE: Optional Wood Blade Holders (BH20 series) and B4000
wood blades are available for this assembly. Not for Damp
Location usage.
FP20
Short Neck
Pulley
Assembly (1)
Blade Holder to Hub Screws,
3/16"-24 x 3/8" (5)
Wood Blade Holders
(for use with FP1022, FP1026,
FP1030 blade sets) (2)
Traditional Blade Holders
(for use with Palm, Bamboo,
Wicker blade sets) (2)
Wood Blade Screws,
10-32 x 1/2" (5) 3/16"-24 x 1/2" (7)
& Fiber Washers,
Ø12.5 x Ø5 x 1mm (7)
Belt (1)
NOTE: The illustration
shown is not to scale or
its actual configuration
may vary.
Parts and packings
subject to change without
notice.