Install The Hardware - Axis Q8414-LVS Guia De Instalacion

How to install the product

Install the hardware

NO NO TICE NO TICE TICE
• The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the midspan shall be shielded (STP) and intended for their specific use.
Make sure that the midspan is properly grounded. For information about regulatory
requirements, see Regulatory information on page 4.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the front of the
camera assembly until the installation is complete.
The Axis product can be installed with the cables routed through the wall or ceiling.
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the camera assembly.
• A standard or high capacity SD card (not included) can be used to store recordings locally
in the product. To install an SD card, see page 14.
• To route the cables before installing the product, see page 9.
• To install the product, see page 10.
Route the cables
1. Measure a triangular area in the corner between the ceiling and the walls.
2. Route the network cable (and the I/O, audio cable if neccessary) through the triangular
area of the wall.
AXIS Q8414–LVS Network Camera
9
EN