Display Ups/Power Conditions - Tripp-Lite OMNIVSX850 El Manual Del Propietario

Basic Operation

Display UPS/Power Conditions

On-Line AC Power Mode LCD Data
The LCD touchscreen offers five screens of UPS and site power information when the UPS is
operating in line-power mode. Screens 1-4 (Output Voltage, Input Voltage, Load %, Battery Charge
Level) are available for viewing in line-power mode. Press the front panel LCD to advance to the next
screen. Screen 5 (Overload) is displayed automatically only when the UPS is loaded to levels greater
than 110%.
The LCD screen reports that AVR (Auto Voltage Regulation) buck/boost circuits are active any time
the line power icon is flashing.
1
Output Voltage
4
Battery Charge Level
Note: The LCD touchscreen automatically turns off in line-power mode 20 seconds after it was last touched. To
re-activate the LCD for an additional 20 seconds, touch the screen.
Operating Mode
Battery Mode
Line Mode
Fault Mode
18-07-252-93388F.indb 6
2
Input Voltage
5
Overload
Normal
Battery Low
Over Load
Normal
Over Load
Battery Replace
3
Load %
Alarm Description
No Alarm
Sounds Every Second
Sounds Every 0.5 Second
No Alarm
Sounds Every 0.5 Second
Sounds Every Minute
Sounds Continuously
6
10/3/2018 10:10:24 AM