DeWalt DW488 Manual De Instrucciones página 7

383763-01/DW488 rev. 7/31/2002
FIG. 1
TRIGGER
SWITCH
SWITCH LOCKING
BUTTON
FIG. 3
SPINDLE
DISC NUT
HUB
BACKING PAD
ABRASIVE DISC
1:48 PM Page 3
AUXILIARY HANDLE CAN
BE INSTALLED ON EITHER
SIDE OF THE GEAR CASE
FIG. 2
AUXILIARY
HANDLE
FIG. 4
SPINDLE
LOCK
BUTTON
3
CAUTION: Wear appropriate hearing protection during use.
Under some conditions and duration of use, noise from this product
may contribute to hearing loss.
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
SAVE THESE INSTRUCTIONS
Switch
To start the tool, squeeze the trigger switch shown in Figure 1. To turn
the tool off, release the switch.The tool can be locked on for
continuous use by holding the trigger switch depressed while you
depress the switch locking button next to the trigger, as shown in
Figure1. Hold the locking button in as you gently release the trigger.
Release the locking button and the tool will continue to run. To turn
the tool off from a locked on condition, squeeze and release the
trigger once.