Saeco Nina plus Instrucciones De Uso página 18

(Fig.3) - Press the ON/OFF button (2).
(Fig.19) - Switch the selection knob (17) to the " "
position.
for steam ejection.
(Fig.18) - Place a container under the steam spout.
(Fig.5) - Open the knob (4) for a few seconds, so that
In a short time only steam will come out.
cappuccino with cold milk.
(Fig.20) - Immerse the steam spout in the milk and open
the knob (4) by turning it anticlockwise. Turn the milk
container with slow upward movements so that it warms
up evenly.
recommended.
cup with the frothed milk.
(Fig.19) - Switch the selection knob (17) to the "
position.
If both lights are on and the machine has reached a too
high temperature to brew coffee, prime the circuit as
described in section 4.5 to make the machine ready for
use.
ready" light (15) is permanently on.
not possible, prime the circuit as explained in
The same procedure can be used to heat other
beverages.
cloth.
9 CLEANING
Maintenance and cleaning may only be carried out
when the machine has cooled down and has been
disconnected from the power supply.
parts in a dishwasher.
agents.
with fresh water daily.
(Fig.21-22) - Every day, after heating the milk, remove
the external part of the Pannarello and wash it with fresh
drinking water.
(Fig.23) - Clean the steam spout weekly. In order to do
this, please:
- Remove the external part of the Pannarello (for standard
cleaning).
- Loosen the ring nut (without removing it).
- Remove the upper part of the Pannarello from the steam
spout.
- Wash the upper part of the Pannarello with fresh drinking
water.
- Wash the steam spout with a wet cloth and remove any
milk residue.
- Replace the upper part of the steam spout (make sure
it is completely inserted).
- Tighten the previously loosened ring nut.
Reassemble the external part of the Pannarello.
(Fig.24) - Empty and clean the drip tray daily
(Fig.17) - Perform the following operations to clean the
"
- (Fig.10)
water.
with hot water.
microwave and/or in a conventional oven.
The formation of limescale inside the appliance is
inevitable. It is necessary to descale the machine every
1-2 months of use and/or when you notice a reduction in
the water delivery.
machine (Fig.B). It has been specifically
developed to preserve performance and functionality
throughout the lifetime of the machine and to ensure,
Warning! Do not use vinegar as a descaling
solution.