Milestone Secura QXL12 Manual Del Usuario página 10

3 Mount the Wall Plate
1. Locate studs. Verify the center of the stud with an awl or
thin nail or use an edge to edge stud fi nder.
2. Level the wall plate [01] and mark the hole locations.
3. Drill pilot holes as illustrated. Pilot holes MUST be drilled
to a depth of 75 mm (3 in.), using a 5.5 mm (7⁄32 in.)
diameter drill bit.
4. Tighten the lag bolts [04] only until the washers [05] are
pulled fi rmly against the wall plate [01].
CAUTION:
Avoid potential injuries or property damage!
Do not over-tighten the lag bolts [04].
Any material covering the wall must not exceed 16 mm
(5/8 in.).
Minimum wood stud size: common 51 x
102 mm (2 x 4 in.) nominal 38 x 89 mm
(1¹∕2 x 3¹∕2 in.).
Minimum horizontal space between
fasteners: 406 mm (16 in.).
10
Wood stud
1
3
75 mm
(3 in.)
13 mm
(1/2 in.)
2
406 mm
(16 in.)
< 16 mm
(5/8 in.)
4
[04]
5.5 mm
(7/32 in.)
[01]
[01]
[05]
[01]