Indicator Lights - Tripp-Lite OMNISMART El Manual Del Propietario

All manuals and user guides at all-guides.com

Indicator Lights

All Indicator Light descriptions apply when the UPS is plugged into a wall outlet and turned on.
This green light will turn ON whenever your UPS is plugged in and
receiving normal AC line power.
This red light will turn ON when your UPS is providing your equipment
with battery power.
This red light will turn ON when the UPS's capacity has been exceeded
while it is operating from battery power (either during a self-test or
during a blackout). Remove overload from battery-supported outlets
immediately.
Available on
select models
This yellow light will turn ON continuously after you test your UPS
battery's charge with the "Mute/Test" Switch to indicate that the UPS's
battery is less than fully charged. If it stays on continuously, contact
Tripp Lite for service. The light will flash after you set the "OFF/ON"
Available on
select models
Switch to the "OFF" position to indicate that the UPS will not provide
battery backup during a blackout or brownout.
Whenever your UPS is automatically correcting high or low AC line
voltage, this green light will turn ON and the UPS will gently click. The
more the UPS has to correct voltage, the more the green light will turn
ON and the more the UPS will click. These are both normal, automatic
Available on
operations of your UPS, and no action is required on your part.
select models
Other UPS Features
AC Receptacles: The receptacles provide your connected equipment with AC
line power during normal operation and battery power during
blackouts and brownouts. They also protect your equipment
against damaging surges and line noise. Select models,
however, feature "surge-only" receptacle(s) (identified on the
back of the UPS) that provide peripherals with surge protec-
tion without committing precious battery power to support
them during blackouts.
RJ11 Telephone Jacks (Available on select models): These jacks protect your
equipment against telephone line surges. Connecting your
equipment to these jacks is optional. Your UPS will still work
properly without this connection.
DB9 Port (Available on select models): The DB9 port connects your UPS to any
workstation or server. Use with Tripp Lite software and cabling
to automatically save open files and shut down equipment
during a blackout. This port sends contact-closure signals to
indicate line-fail and low-battery status. Contact Tripp Lite
Customer Support for more information.
Battery Replacement Door: Under normal conditions, the original battery in
your UPS will last several years. Battery replacement should
be performed only by qualified service personnel. Refer to
"Battery Warnings" in the Safety section on page 2.
5