Important Instructions Regarding Safety And Environment; Electrical Safety; Installation Safety - Beko GN1406231XBN Manual De Usuario

Important instructions regarding safety and environment

A

1.3 - Electrical safety

The product must be unplugged during
installation, maintenance, cleaning, repairing and
moving procedures.
If the power cable is damaged, it must be
replaced by a qualified person specified by
the manufacturer, authorised service agent or
importer in order to avoid potential dangers.
Do not squeeze the power cable under or behind
the product. Do not place heavy objects on the
power cable. Power cable must not be bent
excessively, pinched or get in contact with any
heat source.
Do not use extension cords, multi-sockets or
adapters to operate the product.
Portable multi-sockets or portable power sources
can overheat and cause fire. Therefore, do
not keep any multi-sockets behind or near the
product.
Plug must be easily accessible. If this is not
possible, the electrical installation to which the
product is connected must contain a device
(such as a fuse, switch, circuit breaker, etc.)
which conforms to the electrical regulations and
disconnects all poles from the grid.
Do not touch the power plug with wet hands.
Remove the plug from the socket by gripping the
plug and not the cable.
A
1.4 - Transportation safety
Product is heavy; do not move it alone.
Do not hold its door when moving the product.
Pay attention not to damage the cooling system
or the piping during transportation. If the piping is
damaged, do not operate the product and call the
authorised service agent.
A

1.5 - Installation safety

Call the authorised service agent for installation of
the product. To make the product ready for use,
check the information in the user manual to make
sure that the electricity and water installations
are suitable. If they are not, call a qualified
electrician and plumber to have the necessary
arrangements made. Otherwise, there is the
risk of electric shock, fire, problems with the
product, or injury!
Prior to installation, check if the product has
any defects on it. If the product is damaged, do
not have it installed.
Place the product on a clean, flat and solid
surface and balance it with adjustable feet.
Otherwise, the product may tip over and cause
injuries.
The installation location must be dry and
well ventilated. Do not place carpets, rugs or
similar covers under the product. Insufficient
ventilation causes the risk of fire!
Do not cover or block the ventilation openings.
Otherwise, power consumption increases and
your product may get damaged.
Product must not be connected to supply
systems such as solar power supplies.
Otherwise, your product may get damaged due
to sudden voltage changes!
The more refrigerant a refrigerator contains,
the larger the installation location must be. If
the installation location is too small, flammable
refrigerant and air mixture will accumulate in
cases of refrigerant leakage in cooling system.
The required space for each 8 gr of refrigerant
is 1 m³ minimum. The amount of refrigerant in
your product is indicated on the Type Label.
Product must not be installed in places
exposed to direct sunlight and it must be
kept away from heat sources such as hobs,
radiators, etc.
If it is inevitable to install the product close to
a heat source, a suitable insulation plate must
be used in between and the following minimum
distances must be kept to the heat source:
- Minimum 30 cm away from heat sources
such as hobs, ovens, heater units or stoves,
- Minimum 5 cm away from electric ovens.
Protection class of your product is Type I.
Plug the product in a grounded socket that
conforms the voltage, current and frequency
values stated on the type label of the product.
The socket must be equipped with a 10 A – 16
4 / 30 EN
Refrigerator / User Manual