Care And Cleaning; Troubleshooting - ETI WP-26-850-MV Guía De Uso Y Cuidado

Installation (continued)
7
securing the lens cover to the
fixture plate
□ Rotate the lens cover (B) up to align the two screw
holes at the top of the lens cover (B) with the screw
holes at the top of the fixture plate (A).
□ tighten the screws until the lens cover (B) is secure.
□ Restore power at the electrical panel.
□ turn on the light switch to activate the fixture.
B
A
8
Using silicone sealant between the
wall and the fixture plate
□ to ensure a watertight seal, apply silicone caulk (not
provided) around the back edges of fixture plate (A).
B
A
6

Care and Cleaning

CAUTIoN: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse from the
fuse box.
□ Clean the fixture with a soft, dry cloth.
□ Do not use cleaners with chemicals, solvents, or harsh abrasives.
□ Do not use liquid cleaner on the leDs, leD driver, or wiring inside the light fixture.

Troubleshooting

WARNING: Before doing any work on the fixture, disconnect power to the light fixture.
Minor problems often can be fixed without the help of an electrician.
Problem Possible Cause
the fixture will not light. the power is off.
the circuit breaker is off.
there is a bad connection.
there is a defective switch.
the fuse blows or the circuit breaker the wires are crossed or the power
trips when the light is turned on.
wire is grounding out.
Solution
ensure the power supply is on.
ensure the circuit breaker is in the on position.
Check to ensure proper wire connections are made.
Contact a qualified electrician.
Contact a qualified electrician.
Check the wire connections.
Contact a qualified electrician or call customer
service 1-855-384-7754.
7 www.etissl.com
Please contact 1-855-384-7754 or further assistance.