Assembly - Marshalltown Bullet BT92-2012 Manual De Instrucciones

3
4
SETTING BLADE DEPTH
Turn knob (4) and lift the blade to the top position. Slide a scrap piece of material (5) under the blade. Turn knob (4) to
lower blade until it touches the material. Lower the blade half turn farther. Your blade is now set.
NOTE: Foam and cork backed material must be cut UPSIDE-DOWN
Y
X
Z
X
WS2641
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
2
INSTALL DRIVE CRANK (3) (packed
inside top storage box) by firmly
pressing onto drive shaft and tighten
the screw (1).
Lift blade
Lower blade
5
2

ASSEMBLY

3
1
4
SETTING FENCE POSITION
Lift lock lever to unlatch. Slide fence (2) to desired position.
Press lock lever down firmly to latch in place.
SQUARING FENCE POSITION
1. Loosen Phillips screws (X) on ONE SIDE of
fence track (Y).
2. Tighten Adjustment Set screw (Z) half turn.
3. Tighten Phillips screws (X).
4. Repeat as needed until fence track (Y) is square with
receiver.
INSTALL FENCE (2) by setting the "T"
portion between the steel rail and the
plastic table. Press down on lock lever
to latch in position.
!
WARNING
Scoring too deep
will break your blade!
5
2
5 of 12