Tripp-Lite B126-1A1 Manual Del Proprietário página 17

Extender/Splitter with Remote/Repeater Installation
1
Make sure the HDMI source is powered OFF.
2
Connect the HDMI source to the INPUT port on the B126-002 or
B126-004 using a Tripp Lite P568-Series HDMI Cable.
3
Optional for B126-004: Connect a local monitor to the LOCAL HDMI
port using a Tripp Lite P568-Series HDMI Cable.
4
Connect the external power supply to the local unit and plug it into a
Tripp Lite Surge Protector, PDU or UPS. The green RJ45 LEDs illuminate
to indicate power is being received from the external power supply. An
additional Red LED on the B126-004 also illuminates to indicate power
is being received.
5
Using Cat5e/6 cable, connect one of the RJ45 output ports on the local
unit to the RJ45 input port on the B126-110 remote/repeater unit.
6
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit using a Tripp Lite P568-Series HDMI Cable.
7
Connect the external power supply to the remote/repeater unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green power LED
and the Green RJ45 LEDs illuminate to indicate the unit is receiving
power.
Up to four units can be daisy-chained (three remote/repeaters and one
receiver). To connect additional remote/repeater units, proceed to step 8.
To finish your installation with a B126-1A0 or B126-1A0-WP-1 remote
receiver unit, proceed to step 12.
8
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first remote/
repeater unit to the RJ45 INPUT port on a second remote/repeater unit.
9
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit that you just added using a Tripp Lite P568-Series HDMI Cable.
17-07-081-933731.indb 17
17
8/2/2017 8:57:25 AM