Dimplex Revillusion RBF24DLX El Manual Del Propietario página 9

Installation
Placement
This fireplace is a zero clearance
design, with the exception of the
top of the unit, where any insulation
and vapor barrier should be placed
a minimum of 2" (5.1 cm) from the
fireplace.
CAUTION: The front of the firebox
must not be recessed as this will
prevent adequate airflow out of the
heater.
DANGER!: High temperatures
may be generated under certain
abnormal conditions. Do not
partially or fully cover or obstruct
the front of the fireplace.
WARNING: All electrical heaters
have hot and arcing or sparking
parts inside. Do not use it in areas
where gasoline, paint, or flammable
liquids are used or stored.
WARNING: The electric fireplace
must NOT be in direct contact
with any building vapor barrier or
insulation.
!
NOTE: If the fireplace is going
into an existing opening and used
with the trim accessory, locate the
fireplace as needed for the the best
appearance.
1.
Place the fireplace into the opening.
Level with shims if necessary.
2.
From the inside of the unit, gently
remove the interior brick panels
(attached magnetically).
3
. Screw the mounting flanges directly
to the stud opening or bend the
flange out to 90° to be flush with the
surrounding studs and screwed to
the studs using suitable handware.
Bathroom Installation
This electric fireplace must be
protected by a GFI circuit when
installed in an area where water is
present. If the unit is installed using
a receptacle, it must be readily
accessible.
This fireplace is not watertight and
must be installed as to prevent water
from entering the unit. Install the unit
away from showers, tubs, etc. Keep
towels and other combustible materials
3 feet (0.9 m) away from the front of
the unit.
9