SATA AE5001H Manual Del Uso página 37

4.7 Installation of balance wire rope
Make sure that the left and right sliding tables are at the first
safety position, and then install the balance wire rope as per the
track shown in the figure. Do not tighten the nut temporarily as the
tension of two wire ropes will be adjusted for synchronization later
on. Attention: The unilateral wire rope screw must be tightened with
2 hexagon nuts.
4.8 Installation of bracket arm
Install four bracket arms into the sliding table through the pin,
with three-section straight arms at the front end and two-section
straight arms at the back end.
4.9 Installation of power unit
Install the power unit on the motor board of the main post and fix it with bolts and nuts. Install the limit switch properly and connect the
wires.
4.10 Connection of hydraulic system
Unscrew the hydraulic tank cap and add 10L 46# anti-wear hydraulic oil. (46# anti-wear hydraulic oil is preferred; 32# anti-wear hydraulic
oil is preferred at a temperature below -10° C)
Connect the tee joint and connect the oil pipe to the oil outlet joint of the main and auxiliary cylinders.
AE5001/AE5001-3
中文
EN DE RU
绳轮
Rope sheave
钢 丝绳
Wire rope
KO PT JA ES
螺母
Nut
37