Storage; In The Event Of A Problem - Rowenta PURE AIR GENIUS PU3080 Manual Del Usuario

Pollution sensors
The particle sensor need to be cleaned regularly (every 2 months) and appropriately.
Make sure you turn off and unplug the appliance before cleaning the pollution sensors and follow the
recommendations below:
1. Clean the air inlet and outlet using a soft brush or cloth.
2. Open the sensor cover located on the left hand side of the appliance.
3. Lightly wet a cotton swab and remove any dust from the lens and the inlet/outlet. Wipe using a dry cotton
swab.
4. Clean the sensor using a soft brush or vacuum cleaner.
IMPORTANT:
Never use a detergent or metal object to clean the sensors.
The efficiency of the sensors may be reduced if not cleaned regularly.
Cleaning frequency varies depending on the operating environment of the appliance. If it is used in a
dusty environment, clean the sensors more frequently.

STORAGE

When you are not using the appliance, store it in a cool, dry place with ambient conditions no higher than 35°C
(95°F) 70%RH.

IN THE EVENT OF A PROBLEM

• Do not disassemble the appliance yourself. A poorly repaired appliance may be dangerous for the user.
• Check the troubleshooting table below before contacting an Approved Service Center:
Problem
The appliance does not
switch on.
The air flow does not
change automatically.
The flow is a lot weaker
than before.
There is an unpleasant
smell coming from the air
outlet.
The air quality indicator
does not change color.
Check
Is the power cord connected?
Are all the display elements off?
Is there a power outage?
Is the appliance in manual mode?
Does the filter need to be cleaned or
replaced?
Does the light still indicate poor air
quality?
Is the sensor lens covered with dust?
Solution
Connect the power cord to a plug
with the correct voltage.
Press the on/off button and select the
required function.
You can use your purifier once the
power turns on again.
Select the correct operating mode.
Check the filter cleaning and
replacement frequencies and clean/
replace the filter(s) if necessary.
Check the filter cleaning and
replacement frequencies and clean/
replace the filter(s) if necessary.
Clean the sensor lens.
EN
9