Use Of Electronic Functions - Jacuzzi play SPHERE 90 Uso Y Mantenimiento

Tap fixture with single control
E
D
Before you use any function, you should adjust the water tempera-
ture to the value you want by doing the following:
I Turn the ring nut (G) of the deviator to the "shower head" position.
I Raise the lever of the mixer (M) and turn it to the right or left
until a desirable temperature is reached.
I Once the required water temperature has been reached, turn
the dial (G) to the position that indicates the function you want
to use

Use of electronic functions

Before using the electronic functions, make sure that the master switch in-
stalled above (see "Electrical Safety" chapter) is on. When the shower en-
closure is powered, the LED (4) on the display is on.
1
A
B
C
G
M
4
3
2
STEAM BATH
Jacuzzi authorized service centres offer single-piece packages of per-
fumed sticks, to be used as explained below.
I To extract the dispensers from their seats, proceed as indicat-
ed (it is also possible to press on the lower part). Then insert the
perfumed sticks, or a few drops of your favourite fragrance, and
close the dispensers by pressing until they are fastened.
It is advisable to cut the stick into two pieces, placing one in each dis-
penser (the shower enclosure has two steam outlets, located on the
sides of the column).
2b
I Press the button "I/O" (1): the LED begins to flash.
I After about 2 minutes (the LED begins to flash more slowly) the
water begins to heat up; after a very short time, steam begins to
come out of the nozzles located alongside the columns.
N.B. Condensate might come out of the nozzle; however, this will stop
once the temperature is stable.
11
3
2a