Operating With Repeaters And Setting Of Ctcss Or Dcs Tones; Setting The Frequency Offset And Its Direction; Setting The Ctcss And Dcs Tones In Tx; Setting A Ctcss Or Dcs Tone In Rx - Midland CT3000 Manual De Instrucciones

Operating with repeaters and setting of
CTCSS or DCS tones

Setting the frequency offset and its direction

1. Select the rx frequency on the A or B band.
Set the offset direction: press the FUNC button for 3 seconds. Select
2.
the desired offset with the main knob or by the UP/DOWN controls on
the microphone: CHANNEL MENU -OFFSET SET . The offset set by de-
fault is 5 MHz.
3. When the offset frequency is displayed press FUN. The display will show
-: this means that an offset with negative direction has been set, therefore
the tx frequency will be lower than the rx frequency. If you want to set an
offset with positive direction, press FUN again. Now + will appear on the
display and the tx frequency will be higher than the rx one.
4. For confirmation press the main knob.

Setting the CTCSS and DCS tones in TX:

1. Keep pressed FUNC on the front panel of the radio to access the radio
menu;
2. Select CHAN MENU;
3. Now select TCDT;
4. Select CTC o DCS with the main knob;
5. Set the desired CTCSS tone or DCS code by keeping pressed the main
knob for a few seconds
6. Turn the knob to select the desired tone; press it to set the tone.
7. Press P3-Back to exit the menu and return to stand-by mode.

Setting a CTCSS or DCS tone in RX

1. Push FUNC on the front panel to enter the radio menu;
2. Select CHAN MENU;
Select RCDT;
3.
Now select CTC or DCS with the main knob;
4.
Set the desired CTCSS tone or DCS code by keeping pressed the main
5.
knob for a few seconds
6. Turn the knob to select the desired tone; press it to set the tone.
7. Press P3-Back to exit the menu and return to stand-by mode.
Midland CT3000 instruction guide | 17