Description; Purpose; Overview; Packing List - Powerworks PD24DD60 Manual Del Operario

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used for three functions: driver (a), drill (b)
and hammer drill (c) in all types of wood materials (lumber,
plywood, paneling, composition board, and hard board),
ceramics, plastics, fiberglass, laminates and metals. The
machine is also intended for driving in and loosening screws
and bolts.
1.2

OVERVIEW

Figure 1.
1 Two-speed gear train
( HI-LO)
2 Mode selection ring
3 Torque adjustment ring
4 Keyless chuck
1.3

PACKING LIST

Hammer drill
1
Double sided bit
2
Belt clip
3
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, contact to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
5 LED light
6 Switch trigger
7 Belt clip
8 Reversing button
Screw
4
Manual
5
WARNING
WARNING
WARNING
English
3.2

INSTALL THE BATTERY PACK

Figure 2.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3

REMOVE THE BATTERY PACK

Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4

INSTALL THE BIT

Figure 4.
1. Push reversing button in the center position to lock the
switch trigger.
2. Open or close the chuck jaws.
3. Lift the front of the machine to keep the bit from falling
out of the chuck jaws.
4. Put the bit into the point.
5. Tighten the chuck jaws.
Turn the chuck body to close the chuck jaws. Do not use a
wrench to tighten or loosen the chuck jaws.
Put the bit straight into the chuck jaws. Do not put the bit
into the chuck jaws at an angle then tighten.
3.5

REMOVE THE BIT

Figure 5.
1. Push reversing button in the center position to lock the
switch trigger.
2. Open the chuck jaws.
3. Remove the drill bit.
4
WARNING
NOTE
WARNING