Troubleshooting; Replacement Filter - Stinger WD20250 Manual Del Propietário

Cleaning
To keep your Wet/Dry Vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.

Troubleshooting

Problem
Vac will not pick up dirt
Vac will not run
WARNING: If any of the power head assembly parts should become
detached or broken, exposing motor or any other electrical components,
operation should be discontinued immediately to avoid personal injury or
further damage to the vacuum. This vacuum has no user serviceable parts.

Replacement Filter

Replacement filters are available where
you purchased your Vac. The stock
number is VF2000.
Storage
Before storing your Vac, the dust drum
should be emptied and cleaned. The cord
should be wrapped around the unit and
the hose should be stored as described in
the cord/hose storage section in this
manual. Accessories should be kept in the
same area as the Vac so they can be
readily available. The Vac should be stored
indoors.
Cause
1. Clogged filter
2. Clogged hose
3. Air leak
1. No electricity
11
Remedy
1. Clean or replace filter
(follow instructions on
page 10)
2. Remove hose and
clear debris.
3. Make sure power
head is securely
attached to dust drum.
1. Make sure electrical
outlet has voltage.
(A qualified electrician
may need to be
contacted).