Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1
FAN
SWITCH OR SPEED CONTROL
2
WIRING BOX
MOTOR ASSEMBLY
3
GREEN WIRE AND GROUND SCREW
INSIDE WIRING BOX
ELECTRICAL CABLE
NOTE: Fan can be installed in outside walls
up to 10" thick. Walls less than 6" thick will not
use the adjustable duct. Choose a location with
no obstructions. Fan can be operated by a wall
switch or speed control (available separately).
WARNING: When cutting or drilling into wall, do
not cut existing electrical wiring.
CAUTION: Do not mount fan above cooking
surface.
CAUTION: Before cutting opening, make sure to
mark center of opening on two sides of wall.
Cut a 6-3/8" diameter opening in the outside wall
If using the adjustable duct, cut a 6-3/8" diameter
opening in the inside wall. If not, cut a 6-1/8"
diameter opening in the inside wall.
Remove wiring box from fan:
Unplug motor, loosen screw and remove electrical
wiring box cover.
Push electrical wiring box into housing and lift out.
NOTE: For easier removal of wiring box, remove
the motor assembly. Loosen the
screws and rotate the motor assembly.
WARNING: Switch power off before making
electrical connections.
Remove knockout on wiring box using flat blade
screwdriver and pliers.
Attach power cable to electrical wiring box and
switch box using the proper connector for the type
of cable being used.
Make electrical connections. Connect black to
black, white to white, and bare or green wire to
box using green ground screw.
mounting
2
Publicidad
