Intended Use; Charging Procedure - Lista CSB-20 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for cutting and trimming
hedges and bushes in domestic use.
1. BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
NOTE:
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE
FIG A1)
Depress the Battery Pack Release Button firmly
first and then slide the Battery Pack out from your
tool.
A1
C) TO INSTALL THE BATTERY PACK (SEE FIG
A2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
A2
WARNING: DO NOT USE THE PRODUCT
WITHOUT ATTACHING THE GUARD.
D) CHARGER (ACG18LD3/ACG1830D)
CHARGING YOUR BATTERY PACK (SEE FIG.
B1, B2)
Do not use any charger other than that
specifically provided for use with the equipment.
If the battery pack is very hot you must remove
your battery pack from the charger and allow time
for the battery to cool down before recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long
periods of time, charge the battery every 3
months.
green
light
B1
B2

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, make
sure the battery is in the correct charge position
firmly. The light will turn to red to indicate the
charging process has started.
red
light
33

Publicidad

Tabla de contenido
loading

Tabla de contenido