Safety; Foreword; Introduction; Machine Description - KLOP INNOVATIONS AC Manual De Usuario

AIRCLEANER
AC
TABLE OF CONTENTS

Safety

15

Foreword

17

Introduction

17

Machine description

19
Commissioning 20
14 14
Parts and accessories 20
Specifications 21
Replacing filters 21
Maintenance 22
1 Safety
This section describes safety instructions for the Aircleaner AC. Read this
section carefully before using or servicing the Aircleaner AC.
1.1 Safety symbols in this manual
The following symbols are used in this
user manual:
Ù
A notification alerts the user to
possible problems.
Ú
Risk of damage to the Aircleaner AC if
the instructions are not followed
carefully. Risk of serious injury to the
user if the instructions are not
followed carefully.
1.2 Use
The Aircleaner AC should only be operated
by qualified personnel.
The safety instructions mentioned in this
manual must be observed. If you deviate
from these instructions, this can lead to
serious personal or material damage.
Ù
GENERAL
• Use only filters specified by the
manufacturer
• To ensure proper operation, do not seal or
block the air inlet and outlet
• This appliance is suitable for children aged
8 and older and for persons with reduced
physical, sensory or mental capabilities or
lack of experience or knowledge, provided
that they are supervised or instructed in
the safe use of the appliance and are made
aware of possible dangers.
• Children may not play with the device.
The Aircleaner AC should only be operated
by qualified personnel.
Ú
The safety instructions mentioned in
this manual must be observed. If you
deviate from these instructions, this
can lead to serious personal or
material damage.
Ù
IMPORTANT
• For indoor use only
• Always place the Aircleaner AC on
a dry, flat surface
• Always use the Aircleaner AC at an
ambient temperature of 10°C to 40°C
• Do not place any other objects on the
Aircleaner AC
Ù
DO NOT USE:
• In a wet and/or uncovered environment
• In an explosion-prone area
• As a chair, saw table or similar
applications
Ù
Immediately disconnect from power
supply/mains/socket if:
• Condensation is visible
• A defect has been found on the power cord
• The motor is overloaded and has failed
• In case of damaged housing where
the internal wiring and/or electronics
are visible
Ù
The use of this product does not
serve as a substitute for personal
protective equipment
15 15
EN