Benchtop Models; Electrical Connection; 4�5 Compressed Air Supply; Operation - Renfert Twister Manual De Instrucciones

4.3

Benchtop Models

The stand (18) can be used to convert the vacuum mixer to a floor-mount-
ed appliance�
⇒ Position the stand on a level surface�
⇒ Hang the appliance in the stand�
⇒ Secure the appliance by tightening the knurled nut (9)�
Tighten the knurled nut securely.
The stand is not part of the standard delivery and must be ordered as an
optional accessory (refer to section „3�3 Accessories")�
4.4

Electrical connection

Ensure the mains supply and voltage marked on the nameplate is
identical.
⇒ Secure the mains cable (16) through the cable safety catch (8)�
⇒ Plug mains cable into socket (7) on
⇒ Plug in at the mains�
4.5 Compressed air supply
Twister venturi only
⇒ Plug the compressed air horse (17) into the tube attachment on the
compressed air connection (11) as far as it will go� There will be a slight
resistance to overcome when attaching�
⇒ Select the proper coupling from the set (15, Fig� 1) provided and install it
on the other hose end to connect it to the compressed air system�
⇒ Connect to compressed air line system�
In previous devices, the inlet filter (12) was situated outside the device
(Fig. 5-b). In these cases, push the compressed air horse (17) onto
the inlet filter (12). There will be a slight resistance to overcome
when attaching.
NEVER operate the device without the inlet filter!
The best vacuum performance is attained at the operating pressure
specified in the technical data (see section 8). Use filter pressure reg-
ulator if necessary (see section „3.3 Accessories").
The vacuum mixer is now ready for operation�
5

Operation

5.1

Key Symbols

Mixing parameters
Mixing time
Speed
Vacuum
*) Twister, no� 1826: in 5 % increments
**) Twister venturi, no� 1827: Choice of 80 % and 100 % vacuum levels only�
appliance�
Symbol Adjustment range
0:00 - 9:55
min:sec
100 - 450
1/min
70 - 100 *)
80 / 100 **) %
- 7 -
18
9
8
11
17
12
17
Factory setting
1:00
350
100
EN
Fig. 3
7
16
Fig. 4
Fig. 5-a
Fig. 5-b