Read This First - ABB Power Factor Controller RVC Instrucciones De Operación

4
Thanks for selecting RVC range of PF controllers for your automatic ca-
pacitor bank.

READ THIS FIRST

About this instruction manual
This Instruction Manual is designed to help you quickly install and op-
erate the RVC Controller. Before installation and operation of the
RVC Controller, read this notice carefully. Keep it at the disposal of
people in charge of installation, maintenance and operation.
Safety
Installation, maintenance and operation of the PF controller
must be performed by qualified electricians. Disconnect all
power connections before working on the PF controller.
For cleaning, remove the dust with a dry cloth. Do not use abrasives,
solvents or alcohol. Before cleaning please turn off the power supply.
Do not open the PF controller's housing. There are no user serviceable
parts inside.
The PF controller is connected to a current transformer. Do not unplug
the current transformer connections before making sure it is short-cir-
cuited or connected to another parallel load of sufficiently low imped-
ance. Failure to do so can create dangerous over voltages.
Do not use this product for any other purpose than its original aim.
All cables connected to the PF controller must conform to the local
regulations. They should be able to withstand at least 60°C ambient
temperature. External disconnection devices (e.g. a switch) and exter-
nal overcurrent protection devices (e.g. fuses) must be provided for
the protection of the PF controller (refer to # 6, F1 and F2) and for the
protection of the capacitor bank (refer to # 6, F3, F4 and F5). These de-
vices must be installed in the same cubicle as the PF controller. The
typical protection level of the disconnection circuits for the PF control-
ler is 6A. For the capacitor bank, the protection level depends on its
rating.
R VC M A N U A L E N G L I S H