Plunge Cutting Using The Guide Rail; Cleaning And Maintenance; Disposal - Parkside PTSS 1200 C2 Traducción Del Manual De Instrucciones Original

Mitre angles up to 45°
♦ Apply the guide rail
elements onto the workpiece.
♦ Place the appliance with the groove
the guide rail .
♦ Adjust the cutting angle as described.
♦ Hold the machine with both hands firmly on
the handles and
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance
with the front part of the base plate
workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.

Plunge cutting using the guide rail

♦ Apply the guide rail
elements onto the workpiece.
♦ Place the appliance with the groove
the guide rail .
♦ Adjust the desired cutting depth as described
above.
♦ Place the rear edge (as far as possible) against
a stop.
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on
the handles and
NOTE
► The cutting width marking
of the blade guard shows the front and rear
cutting point of a 165 mm saw blade at
maximum cutting depth. This applies both
for plunge cuts using the guide rail
plunge cuts without using the guide rail
Further applications are not permitted.
PTSS 1200 C2
with the foam rubber
onto
.
on the
with the foam rubber
onto
and pivot it.
on the side
and
.

Cleaning and maintenance

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.

Disposal

The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling
plant.
Do not dispose of power tools
in your normal domestic waste!
European Directive 2012/19/EU
requires that worn-out power tools are
collected separately and recycled in an environ-
mentally compatible manner.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The pack-
aging material is labelled with abbreviations (a)
and numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
Your local community or municipal
authorities can provide information
on how to dispose of the worn-out
product.
The product is recyclable, subject to
extended producer responsibility and
is collected separately.
GB │ IE │
11 ■