Deinstallation; Disconnecting The Lines - Steinbach Waterpower 5000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 145
The temperature of a temperature sensor appears on the display.
3. Press the Clock button
You can switch between the different temperature sensors by pressing the Clock
button
again (see "Display" section). If there is not input for more than 10
13
seconds, the temperature display disappears from the display.
4. Press the ON/OFF button
The temperature display disappears. The display shows the regular operating mode
content.

Deinstallation

Disconnecting the lines

Disconnecting the power supply
1. Put the heat pump into standby mode (see "Display" section).
2. Disconnect the power plug
All display elements on the display
power supply and is not in operation.
Disconnecting the water lines
1. Deactivate the water treatment pump.
2. Completely loosen the union nut
3. Pull off the supply line at the inlet water connection
When removing hose end of the water line, hold it with the opening facing upward
so that residual water in the hose does uncontrollably run out.
4. Completely loosen the union nut
5. Pull off the drain line from the outlet water connection
When removing hose end of the water line, hold it with the opening facing upward
so that residual water in the hose does uncontrollably run out.
The water lines are disconnected.
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled tipping of the
device can result in injuries or damage to the device.
- Only lift, carry or tip the device with two people, never alone.
62
.
13
.
18
from the supply line to the power supply.
9
disappear. The heat pump is disconnected from the
C
on the inlet water connection
2
on the outlet water connection
2
CAUTION!
.
8
.
8
.
6
.
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bp-50hs-a1049202

Tabla de contenido