Operation And Maintenance - GRAPHITE 59G607 Manual Del Usuario

●
Pos 0 (middle position of the switch) – switched off.
●
Pos II (bottom position of the switch) – vacuum cleaner can only be used with external device (power
tool) connected to power socket of the vacuum cleaner.
When using the vacuum cleaner to gather materials which are not harmful to health, they can be collected
in the tank (6) directly, use of pleated filter or dust bag is not necessary.
EXTRACTION OF DUSTS AND SCOBS PRODUCED DURING POWER TOOL OPERATION
● Put dust bag to clean heavy dirt or pleated filter (a) into the vacuum cleaner.
●
Place power tool plug in the mains socket (
exceed 2000 W) (fig. K)
●
Switch on the vacuum cleaner – press the switch (
In this mode of operation vacuum cleaner can only be used with power tool connected. Remember
that the vacuum cleaner will be switched on automatically (with short delay) by power tool connected
to the socket.
Vacuum cleaner socket can be used only for purposes specified in this instruction manual.
When sucking off gypsum dust use pleated filter and dust bag.
WET OPERATION
Do not use the vacuum cleaner to suck off flammable or explosive liquids, such as petrol, oils,
alcohols, solvents etc. and hot or glowing dusts and materials.
Foam membrane filters out large contaminations from liquids.
●
Release fixing clamps (
●
Remove pleated filter (
●
Empty the tank from dirt.
●
Ensure the float ( h) can elevate in its ring in straight line (b) (fig. L).
●
Put foam membrane (
●
Install upper body ( 7) and secure with fixing clamps (3).
When water reaches its maximum allowable level in the tank, sound produced by motor changes
noticeably. Switch off the vacuum cleaner immediately and empty the tank.
EMPTYING DIRTY WATER FROM CONTAINER
● Place tray or other vessel and unscrew the drain plug (9) (fig. N).
●
Once the water has been drained screw in the drain plug (
BLOWING THROUGH
To blow through (e.g. dirt deposited in corners) remove the suction hose from the connection socket (4)
and put it in the hole of upper hook for power cord (12) located in the upper body (7) (fig. O).
Disconnect the tool from power supply network before starting any adjustment, maintenance or
repair.
●
Regular cleaning assures longer maximum suction efficiency.
●
Clean dirt and dust off the vacuum cleaner body with damp cloth. Do not allow water to get inside
the motor.
●
Empty, clean and dry carefully the tank each time after cleaning wet dirt and liquids. Liquids and wet
dirt speeds up growth of bacteria.
●
If pleated filter was used, remove and clean with a brush. Frequency of pleated filter cleaning depends
on type and amount of dusts. Replace filter with a new one when necessary. Use only original pleated
filters.
●
Float and foam membrane must be cleaned and dried thoroughly to avoid growth of mould.
●
If dust bag was used, replace with a new one when it is full.
●
Store the vacuum cleaner in dry place, beyond reach of children.
●
Entrust replacement of power cord and other repairs only to authorized service workshop.
2) (power consumption of connected power tool must not
3) on both sides of the device and remove upper body (7).
a) and/or dust bag.
i) onto the ring (b) of the float (h) (fig. M).

OPERATION AND MAINTENANCE

8) to pos. II.
9).
15